Install the sensor and magnet in a position where the following conditions are satisfied. Refer to the Quick Start Manual, where you can learn how to install the unit in detail using a movie.Īttach the bracket to the stem or handlebarġ-1 When mounting the bra cket to the stemġ-2 When mounting the bracket to the handlebar * Generally, the tire size or ETRTO is indicated on the side of the tire. Refer to the tire circumference reference table Measure the tire circumference (L) Measure the distance when the tire turns right round with your weight applied, while adjusting the tire pressure appropriately.Tire circumference There are the following ways to determine the tire circumference. Pressing and holding the MODE button switches the display to "Displayed time", "Hour", and "Minute" in order. * Refer to the "Tire circumference reference table" as a guide. Press the AC button on the back of the computer.Įnter the front wheel tire circumference of your bicycle in mm. Perform the All Clear operation, when you use the unit for the fi rst time or restore the unit to the condition checked at the factory. Hereby, CATEYE Co., Ltd., declares that this CC-RD310W is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC. May void the user 's authority to operate the equipment. The FCC requires the user to be notified that any changes or modifications made to this device that are not expressly approved by CatEye Co., Ltd. this device must accept any interference received, including interference that may cause undesired operation.This device may not cause harmful interference, and.Operation is subject to the following two conditions: This device complies with Part 15 of the FCC Rules. Using with other wireless devices, or some particular battery lights.Close to a railroad crossing, railway tracks, TV stations and/or radar base.Near a TV, PC, radio, motor, or in a car or train.Interference may occur, resulting in incorrect data, if the computer is: Signals can be received only when the back of the computer is facing the sensor.The receiving distance may be shortened due to low temperature and exhausted batteries.Signals cannot be received if the distance between the sensor and the computer is too large.When adjusting the wireless sensor, note the following: The sensor was designed to receive signals within a maximum range of 60 cm, to reduce chance of interference. LCD screen may be distorted when viewed through polarized sunglass lenses.Dispose of used batteries according to local regulations. Risk of explosion if battery is replaced by an incorrect type.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |